Exit

Logie

T. E. Pryce-Tannatt, 1914

Step 1 of 10

Thread base — Tie in the gut loop first on the blind-eye hook. Start the thread behind the eye and take it in touching turns to the point above the barb. Keep the foundation very slim. Technique: Mounting a blind-eye hook

No photo or clip for this step yet — the text and the check stand alone.

Step 2 of 10

Topping — Tie in one golden pheasant crest as the tail. Set the curve naturally and make the tail extend past the hook bend.

No photo or clip for this step yet — the text and the check stand alone.

Step 3 of 10

Fine oval rib — Tie in fine oval silver tinsel at the rear of the body and carry the thread forward.

No photo or clip for this step yet — the text and the check stand alone.

Step 4 of 10

Primrose section — Tie in pale primrose floss. Wind it forward for the first two-fifths of the body, keeping the floss flat and the transition square. Tie off without building a bulky step.

No photo or clip for this step yet — the text and the check stand alone.

Step 5 of 10

Ruby-red section — Tie in ruby-red floss at the primrose transition and wind it forward over the remaining three-fifths. Keep the color change clean and the body slim.

No photo or clip for this step yet — the text and the check stand alone.

Step 6 of 10

Silver rib — Counter-wind the fine oval silver tinsel in five or six evenly spaced turns. Tie off at the head end and trim.

No photo or clip for this step yet — the text and the check stand alone.

Step 7 of 10

Pale-blue throat — Tie in a pale-blue hackle by the tip. Make two or three turns only, forming a short, sparse throat beneath the body. Technique: Winding a throat hackle

No photo or clip for this step yet — the text and the check stand alone.

Step 8 of 10

Yellow Swan wing — Prepare a matched pair of yellow swan strips (or goose). Tie them upright and close together, extending rearward to about the end of the topping. Technique: Setting a paired wing

No photo or clip for this step yet — the text and the check stand alone.

Step 9 of 10

Mallard wing — Prepare matched brown mallard strips and tie them over the swan. Leave a visible margin of yellow showing on both sides so the underwing is not buried. Technique: Setting Mallard

No photo or clip for this step yet — the text and the check stand alone.

Step 10 of 10

Finish — Form a small head, whip-finish, trim the thread, and varnish. Pryce-Tannatt's dressing does not require jungle cock cheeks, so keep the head clean and unadorned. Technique: Finishing a salmon fly

No photo or clip for this step yet — the text and the check stand alone.