Hook Reference › International Nickel Company, Inc. › International Nickel Company, Inc. PR. 8-2640 — Lew Morrison’s Silver Horde Duranickel Hollow Ground Forged Needle Point Fish Hooks

International Nickel Company, Inc. PR. 8-2640

Lew Morrison's Silver Horde Duranickel Hollow Ground Forged Needle Point Fish Hooks

Marks: P photographically · V verified · I inferred · E estimated · S speculative What they mean

Photographic record

4 photographs

Side view of a single barbed hook on grid paper: plain round shank, round bend, long tapering point with a short cut barb, and a curled eye at the right end of the shank.
IMG-1International Nickel Company, Inc. — New entry — image 1 Side view of the photographed hook. The shank is plain and round, the bend continuous, and the point long and slender (P).

Identify

The entry documents one hook and one printed box. The box front reads DURANICKEL, Lew Morrison’s SILVER HORDE, with the legend HOLLOW GROUND, FORGED, NEEDLE POINT.

The front names no hook maker and prints no size.

How to identify it

Look for DURANICKEL in red across the top of the box front, with Lew Morrison’s in black script below it and SILVER HORDE under that. The bottom line gives Box 128, Lynnwood, Wash. and PR. 8-2640 P.

The front prints no model, catalog or size code. PR. 8-2640 follows the address and is formatted like an exchange-and-number telephone listing I. A size has to come from the hook itself.

Measurements & specifications

Features of the model, as recorded
FeatureRecordedEvidence
EyeBall Eye, Straight / Inline
Show noteHide note

Photographed hook: wire end curls into an open C-shaped ring; the free end stops short of the shank and no braze or weld shows P.

OBS-2IMG-3
WireExtra-Heavy (2X+), RoundCMP-3MEA-4CMP-3 compared with 73 catalogued hooks classified Extra-Heavy (2X+)
ShankStandard — Plain
BendRound / Kendal, Standard gap
Show noteHide note

Photographed hook: continuous, even round bend from shank to point, with no kink or flat spot P.

OBS-5IMG-1
PointNeedle
Show noteHide note

Photographed hook: one cut barb on the point's inner side near the bend, angled back toward it, with a step in the point's edge at its base P.

LBL-4LBL-6OBS-6IMG-4OBS-7
FinishNickelled — uncertain
Show noteHide note

Photographed hook: dull gray with a warm brass-brown cast and fine matte grain; ground facet and eye end read lighter. No plating edge, flaking or rust visible P.

OBS-8SRC-2IMG-1IMG-3IMG-4

On the photographed hook, the shank is straight, plain and round in section, with no ridges, serrations or kinks P. The box legend says FORGED, but the side views show no flattened sides along the shank or bend P.

The point is long and slender, with a ground inner facet marked by fine cross-hatching P. The box legend says HOLLOW GROUND and NEEDLE POINT. The slender profile is consistent with a needle point I; whether the facet is concave cannot be judged from these views.

Against the site’s classified catalog, the wire sorts as extra heavy I.

The box names DURANICKEL. A 1963 Alloy Digest datasheet lists Duranickel Alloy 301 as a wrought, age-hardenable nickel alloy produced by International Nickel V. The hook’s own alloy is not stated, so solid alloy and plating both remain possible.

Measurements

Measurements · caliper
Overall length39.4 mm E
Shank length26.7 mm E
Gap width14.7 mm E
Wire diameter1.8 mm E
Calibrated SVG True-scale preview

How the measurements are defined
How hook dimensions are measuredA hook outline with dimension lines for overall length, shank length, gap, bend depth, and wire diameter.Overall lengthShank lengthGapBend depthWire diameter
Overall length
Eye to the farthest point of the bend.
Shank length
Eye to the start of the bend.
Gap
Point to shank, at right angles to the shank.
Bend depth
Shank to the bottom of the bend.
Wire diameter
Across the wire, measured by caliper where possible.

Use & alternatives

  • Saltwater
  • Salmon

Label & packaging

This record documents one specimen. It describes that specimen only, not every example of the model.

S1 · Box front and one hook, size not marked

Container
Box
Hook condition
No rust, pitting or flaking visible. Light scratches on the ground facet; a small dark rough spot at the tip of the eye curl (P).
Packaging condition
Good — moderate wear, legible
Photographs
IMG-1IMG-2IMG-3IMG-4
Detailed condition observations
Wear
front panel, left half of the FISH HOOKS line: small white flecks where ink or surface paper is missing LBL-14
Wear
front panel, center and upper right: mottled brown toning and a few faint stains, including near the right end of the Morrison's line LBL-15
Wear
right edge near the lower corner: small lifted or chipped spot showing brown board LBL-16

The hook and box are paired in this entry; no photograph shows the hook in the box. The front shows light toning, a few stains, small ink loss in the FISH HOOKS line and a minor chip at the lower right edge. The interior, ends, back and contents are not shown.

Full label transcription
LBL-1 printed · front panel, top line, red from IMG-2
DURANICKEL
LBL-2 printed · front panel, below top line, black script from IMG-2
Lew Morrison's
LBL-3 printed · front panel, centered below script from IMG-2
SILVER HORDE
LBL-4 printed · front panel, middle band, left from IMG-2
HOLLOW
GROUND
LBL-5 printed · front panel, middle band, center, large from IMG-2
FORGED
LBL-6 printed · front panel, middle band, right from IMG-2
NEEDLE
POINT
LBL-7 printed · front panel, large line below middle band from IMG-2
FISH HOOKS
LBL-8 printed · front panel, wide-spaced line below FISH HOOKS from IMG-2
GUARANTEED RUST PROOF
LBL-9 printed · front panel, small footnote line from IMG-2
*Trade Name of International Nickel Company, Inc.
LBL-10 printed · front panel, bottom line, left from IMG-2
Box 128
LBL-11 printed · front panel, bottom line, center from IMG-2
Lynnwood, Wash.
LBL-12 printed · front panel, bottom line, right from IMG-2
PR. 8-2640
LBL-13 handwritten · front panel, upper left beside DURANICKEL, red handwriting, 'each' underlined with a swash from IMG-2
15¢ *
each
Trademark
No logo, crest or device is printed on the front.
As entered on the specimen record
DURANICKEL
Lew Morrison's
SILVER HORDE
HOLLOW
GROUND
FORGED
NEEDLE
POINT
FISH HOOKS
GUARANTEED RUST PROOF
*Trade Name of International Nickel Company, Inc.
Box 128
Lynnwood, Wash.
PR. 8-2640
Layout
Centered stack down the front panel: DURANICKEL, the script line, then SILVER HORDE. Middle band: HOLLOW GROUND at left, FORGED large at center, NEEDLE POINT at right. Below come FISH HOOKS, GUARANTEED RUST PROOF and the footnote, then a bottom line reading Box 128, Lynnwood, Wash. and PR. 8-2640 from left to right.
Typeface
DURANICKEL is in red block capitals and Lew Morrison's in black script. The remaining lines are black sans-serif, with FORGED and FISH HOOKS the largest.
Later marks
Red handwriting at upper left: 15¢ * / each, with 'each' underlined by a swash. Whether the red asterisk is hand-drawn or printed is not established.

History & dating

Series

The box names Lew Morrison’s Silver Horde. A web profile written partly in the company’s own voice says Lew and Gladys Morrison founded Silver Horde Fishing Supplies, Inc. in the fall of 1948 V. The profile covers lures and does not mention hooks.

A footnote on the box reads ‘*Trade Name of International Nickel Company, Inc.’ Its referent is probably DURANICKEL I. The footnote does not say who made the hooks.

A 2017 collector forum post describes a box of Duranickel forged hooks from a San Francisco firm, Fred Miller Mfg (V, anecdotal). The word Duranickel therefore appears on hooks from more than one firm I.

Dating

The box carries the Lew Morrison's Silver Horde name, and a web profile dates the start of Silver Horde to the fall of 1948 V. No date is printed on the box front.

International Nickel Company, Inc. Read the maker’s history →

Sources & research

Sources & documentation

This specimen and its packaging — photographed, 4 images
Supports: PointFinishWireConstructionOverall lengthShank length
+13 morefewerGap widthWire diameter measuredMeasurements availableMeasurement notesEyeBendBarbDating rangePackagingSummaryTechnical notesIdentificationSeries history

Open questions

  1. Who made these hooks?The box names Lew Morrison's Silver Horde and, in a footnote, International Nickel Company, Inc. as owner of a trade name. No source found says who made the hooks.Can you help? Send a catalog page, advertisement or dated invoice that names the hook maker.

Entry updated October 28, 2026.